Friday, November 06, 2009

Installation of Hanging pot hanger


In this post I install a half-moon shape pot hanger.

The pot hanger I have had for years was wall-mounted with a bracket. However there is no place convenient in my kitchen to mount it on a wall. Here is how I hung it from the ceiling using chains. It took an hour and a half (or three hours if you count the time at Home Depot and on this blog.)

I hung it above the sink so it can double as a drying rack for the large pots. A pot hanger located above the sink is very convenient because I cook tons of pasta and have pots and strainer out all the time. And it's been a nuisance storing pots on the stove & also taking up dish rack space after washing. There is no dishwasher.

First locate four points where it will hang from ceiling:

about $20 worth of hardware from home depot

Toggle bolts expand above the ceiling to support a load. The holes need to be wide enough to insert them. Below, twisting the wallboard saw to make holes.
Below, what a toggle bolt looks like before installing. Toggle bolts come with screws so I needed to replace them with eye bolts of the proper diameter (1/4 inch) to screw in to toggle.
Ceiling mounts in place, below. S-hooks to connect chain to ceiling mount
With the hardware in place, chain length can be measured and cut so hanger hangs at desired height. Stainless steel chain was about $1.70/foot. I bought five feet but only used half. Any chain would support the hanger so I went with something that looked good.
Below, chain sections after cutting links. Dremel drill with steel-cutting bit used to cut links. Locking pliers used to pull links apart because drill bit would jam right before each cut was complete.
Below, I used hardware at the hanger similar to at ceiling except using nut/washer instead of toggle bolt.
Ta da!

Mohawk Trail leaf peepage

  In this post there is much foliage to be seen between Greenfield and North Adams, in northwest Massachusetts. You'll see a series of p...